Typical Enabling Conditions
| Monitor runs whenever following DTCs not present | P0010 (Camshaft timing oil control valve assembly) P0011 (VVT system - Advance) P0012 (VVT system - Retard) P0016 (VVT system - Misalignment) P0031, P0032, P101D (Air fuel ratio sensor heater - Sensor 1) P0037, P0038, P102D (Heated oxygen sensor heater - Sensor 2) P0102, P0103 (Mass air flow meter) P0107, P0108 (Manifold absolute pressure) P0115, P0117, P0118 (Engine coolant temperature sensor) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle position sensor) P0125 (Insufficient coolant temperature for closed loop fuel control) P0136, P0137, P0138, P0139, P0607 (Rear oxygen sensor - Sensor 2) P014C, P014D (Air fuel ratio sensor - Slow response) P015A, P015B (Air fuel ratio sensor - Delayed response) P0171, P0172 (Fuel system) P0301, P0302, P0303, P0304 (Misfire) P0335 (Crankshaft position sensor) P0340, P0342, P0343 (Camshaft position sensor) P0351, P0352, P0353, P0354 (Igniter) P0401 (EGR system (Closed)) P2195, P2196 (Air fuel ratio sensor - Rationality) P219A (Air fuel ratio sensor - Imbalance) P2237 (Air fuel ratio sensor - Open) P2238, P2252 (Air fuel ratio sensor - Low impedance) P2239, P2253 (Air fuel ratio sensor - High impedance) |
| Auxiliary battery voltage | 11 V or more |
| Intake air temperature | -10°C (14°F) or higher |
| Engine coolant temperature | 75°C (167°F) or higher |
| Atmospheric pressure | 76 kPa(abs)[570 mmHg(abs)] or higher |
| Idling | OFF |
| Engine speed | Less than 4000 rpm |
| Air fuel ratio sensor status | Activated |
| Fuel system status | Closed loop |
| Engine load | 10% or more, and less than 70% |
| All of the following conditions (a), (b) and (c) are met | - |
| (a) Mass air flow rate | 2.5 to 50 gm/sec |
| (b) Front catalyst temperature (estimated) | 520°C (968°F) or higher, and below 770°C (1418°F) |
| (c) Rear catalyst temperature (estimated) | 450°C (842°F) or higher, and below 700°C (1292°F) |