DTC B2313: Glass Position Initialization Incomplete: Procedure

1. Turn the power switch on (IG).
2. Initialize the power window regulator motor assembly. Refer to INITIALIZATION [06/2012 - ] .

   HINT: 

   Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.

NEXT: Go to next step 

1. Turn the power switch off.
2. Wait for at least 10 seconds, and then turn the power switch on (IG).
3. Check for DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .

   HINT: 

   Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.

   OK

   DTC B2313 is not output.

   Result

   Result	Proceed to
   OK	A
   NG (Driver door power window)	B
   NG (Front passenger door power window)	B
   NG (Rear LH door power window)	C
   NG (Rear RH door power window)	C

B → See step   3 

C → See step   4 

A → END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)