Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / P-Door Motor / Data List.
5. Read the Data List according to the display on the Techstream.
   P-DOOR MOTOR
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   P Door P/W Auto SW	Front passenger door power window auto switch signal / ON or OFF	ON: Front passenger door power window auto switch being operated OFF: Front passenger door power window auto switch not being operated	-

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

NG → See step   4 

OK: Go to next step 

1. Initialize the power window regulator motor assembly (for front passenger door). Refer to INITIALIZATION [06/2012 - ] .

NEXT: Go to next step 

1. Check that the front passenger door power window moves when the auto up and down function of the power window regulator switch assembly is operated. Refer to OPERATION CHECK [06/2012 - ] .

   OK

   Front passenger door auto up and down function is normal.

NG → See step   6 

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE) 

1. Remove the power window regulator switch assembly. Refer to REMOVAL [06/2012 - ] .
   Fig 1: Identifying Power Window Regulator Switch Assy & Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   8 (AUTO) - 1 (GND)	Auto up or auto down position	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Power Window Regulator Switch Assembly)

NG → See step   7 

OK: Go to next step 

1. Disconnect the L9 power window regulator motor assembly (for front passenger door) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L4-8 (AUTO) - L9-4 (AUTO)	Always	Below 1 Ω
   L4-8 (AUTO) - Body ground	Always	10 kΩ or higher
   L9-4 (AUTO) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   6