LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2013 >> ES 350 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Occupant Classification System (Diagnostics - Introduction) >> Occupant Classification System >> Data List / Active Test [06/2012 - ] >> Data List / Active Test [06/2012 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test [06/2012 - ]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Turn the engine switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the engine switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical / Occupant Detection / Data List.
    6. Check the values by referring to the table below.
      OCCUPANT DETECTION

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      IG Switch Engine switch condition/
      ON: Engine switch on (IG)
      OFF: Engine switch off      		 ON/OFF -
      Passenger Buckle SW Passenger side buckle switch/
      Set: The seat belt is fastened
      Unset: The seat belt is not fastened
      NG: Data is not determined      		 Set/Unset -
      Passenger Classification Passenger classification/
      AM50: Adult is seated.
      AF05: Adult is seated.
      Child: Child is seated.
      CRS: Child restraint system is installed.
      OFF: Vacant      		 AM50/AF05/Child/CRS/OFF -
      Sensor Range Info Sensor range information/
      OK: The value of a sensor is within the range
      NG: The value of a sensor is over the range      		 OK -
      RL Sensor Range Info Rear left sensor range information/
      OK: Sensor range is -10.00 to 30.00 kg (-22.05 to 66.13 lb)
      Min.: Less than -10.00 kg (-22.05 lb)
      Max.: More than 30.00 kg (66.13 lb)      		 OK -
      RR Sensor Range Info Rear right sensor range information/
      OK: Sensor range is -10.00 to 30.00 kg (-22.05 to 66.13 lb)
      Min.: Less than -10.00 kg (-22.05 lb)
      Max.: More than 30.00 kg (66.13 lb)      		 OK -
      RL Sensor Voltage Rear left sensor voltage/
      Min.: 0.000 V
      Max.: 19.800 V      		 0.000 to 5.000 V -
      RR Sensor Voltage Rear right sensor voltage/
      Min.: 0.000 V
      Max.: 19.800 V      		 0.000 to 5.000 V -
      RL Sensor Weight Info Rear left sensor weight information/
      Min.: -10.00 kg (-22.05 lb)
      Max.: 30.00 kg (66.13 lb)      		 -10.00 to 30.00 kg
      (-22.05 to 66.13 lb)      		 -
      RR Sensor Weight Info Rear right sensor weight information/
      Min.: -10.00 kg (-22.05 lb)
      Max.: 30.00 kg (66.13 lb)      		 -10.00 to 30.00 kg
      (-22.05 to 66.13 lb)      		 -
      Total Weight Information Total weight information/
      Min.: -40.00 kg (-88.19 lb)
      Max.: 100.00 kg (220.46 lb)      		 -40.00 to 100.00 kg
      (-88.19 to 220.46 lb)      		 -
      Number of Present DTC Number of present DTC recorded/
      Min.: 0, Max.: 255      		 0 -
      Number of Past DTC Number of past DTC recorded/
      Min.: 0, Max.: 255      		 0 -
scientia non olet · About LEMON Manuals