Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch: Procedure

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .
2. Check for DTCs. Refer to DTC CHECK / CLEAR [06/2012 - ] .
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC B2311 is output	B
   DTC B2312 is output	C
   DTC B2313 is output	D
   LIN communication system DTCs are output	E

B → See step   9 

C → See step   6 

D → See step   7 

E → See step   5 

A: Go to next step 

1. Check that the front power window moves when the manual up/down function of the multiplex network master switch is operated. Refer to OPERATION CHECK [06/2012 - ] .

   OK

   Front power window moves.

NG → See step   8 

OK: Go to next step 

1. Use the Data List to check if the multiplex network master switch is functioning properly. Refer to DATA LIST / ACTIVE TEST [06/2012 - ] .
   MASTER SWITCH
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver side power window auto up/down signal / ON or OFF	ON: Driver side power window auto up/down switch on power window regulator master switch operated OFF: Driver side power window switch on power window regulator master switch not operated	-

   OK

   On tester screen, item changes between ON and OFF according to above chart.

NG → See step   4 

OK → See step   10