How To Proceed With Troubleshooting [09/2012 - ]

HINT: 

• Use the following procedures to troubleshoot the power mirror control system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT AUXILIARY BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.

   NEXT: Go to next step 

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.
      RESULT:
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

      B → Go to CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2012 - ] 

      A: Go to next step 

4. PROBLEM SYMPTOMS TABLE 
   RESULT:
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B → Go to step 7 

   A: Go to next step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Operation Check. Refer to OPERATION CHECK [09/2012 - ] 
   2. Data List / Active Test. Refer to DATA LIST / ACTIVE TEST [09/2012 - ] 
   3. Terminals of ECU. Refer to TERMINALS OF ECU [09/2012 - ] 

      NEXT: Go to next step 

6. ADJUST, REPAIR OR REPLACE 

   NEXT: Go to next step 

7. CONFIRMATION TEST 

   NEXT → END