Diagnosis System [04/2013 - 06/2014]

1. Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning, use the Techstream to check for malfunctions and to repair it.

1. Check the DLC3.

   Refer to GENERAL INFORMATION [04/2013 - ]

HINT: 

This function is used to check the date and time of occurrence when a camera synchronous error occurs.

1. Check camera synchronous error history.
   1. Connect the Techstream to the DLC3.
   2. Turn the engine switch on (IG).
   3. Turn the Techstream on.
   4. Enter the following menus: Body Electrical / Navigation System / Utility / Camera Synchronous Error History.

      Body Electrical > Navigation System > Utility 

      Tester Display
      Camera Synchronous Error History

   5. When an item is stored for Camera Synchronous Error History, record it before repairing the multi-display assembly and rear television camera assembly.

      HINT: 

      Camera Synchronous Error History can store up to 5 history data items. If a new camera synchronous error occurs when 5 data items have already been stored, the oldest data is cleared and the new data is stored.

2. Clear camera synchronous error history.
   1. When DTCs are cleared using any of the following operations, Camera Synchronous Error History will be cleared as well.

      w/ Navigation System: Refer to DTC CHECK / CLEAR [04/2013 - 06/2014]

      w/o Navigation System: Refer to DTC CHECK / CLEAR [04/2013 - 06/2014]

      • Cleared using the Techstream.
      • Cleared using the system check mode screen.
      • Cleared using the unit check mode screen.

w/ Navigation System: Refer to OPERATION CHECK [04/2013 - 09/2020]

w/o Navigation System: Refer to OPERATION CHECK [04/2013 - 10/2016]