April 5, 2026: LEMON Manuals is launched! Read the announcement.

Precaution [08/2013 - ]

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected:

System	See Procedure
Parking Assist Monitor System	Refer to INITIALIZATION [08/2013 - ]

PRECAUTIONS WHEN WORKING ON STEERING LOCK SYSTEM
1. After replacing the steering lock actuator assembly (steering lock ECU), perform the key code registration.
2. If the steering lock actuator assembly is replaced, open and close the driver's door. The engine may not start until either operation is performed.
  HINT:
  
  Opening and closing the driver's door causes the steering lock actuator assembly (steering lock ECU) to memorize the correct steering lock bar position.
3. If checking for DTCs of the push-button start function or checking the Data List with the engine switch off, make sure that the driver's door is open.
  HINT:
  
  When the engine switch is off, the main body ECU RH (cowl side junction block RH) may be in a sleep mode. If the main body ECU RH (cowl side junction block RH) is in this sleep mode, it will not be possible to communicate with the Techstream.