Air Intake Control Circuit [09/2013 - ]: Procedure

1. Inspect the VSV for air intake control valve. Refer to ON-VEHICLE INSPECTION [09/2013 - ] - Step 3 .

NG → REPLACE VSV (FOR AIR INTAKE CONTROL VALVE) 

OK: Go to next step 

1. Disconnect the VSV for air intake control valve connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Turn the engine switch on (IG).
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   A60-2 - Body ground	Engine switch on (IG)	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (EFI NO. 2 FUSE - VSV FOR AIR INTAKE CONTROL VALVE) 

OK: Go to next step 

1. Disconnect the VSV for air intake control valve connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance (Check for Open)

   Tester Connection	Condition	Specified Condition
   A60-1 - E3-8 (AICV)	Always	Below 1 Ω

   Standard Resistance (Check for Short)

   Tester Connection	Condition	Specified Condition
   A60-1 or E3-8 (AICV) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (VSV FOR AIR INTAKE CONTROL VALVE - ECM) 

OK: Go to next step 

1. Inspect the intake air control valve. Refer to ON-VEHICLE INSPECTION [09/2013 - ] - Step 2 .

NG → REPLACE AIR CLEANER CASE 

OK → See step   5