Installation [04/2013 - 10/2017]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Lexus IS 350, 2017 Lexus IS 300, 2016 Lexus IS 350, 2016 Lexus IS 300, and 2015 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRANKSHAFT POSITION SENSOR
1. Clean and degrease the threads of the bolt for the crankshaft position sensor.
2. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
3. Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  NOTE:
  - If a crankshaft position sensor has been struck or dropped, replace it.
  - Make sure that the O-ring is not cracked or does not move out of place during installation.
4. Connect the crankshaft position sensor connector.
INSTALL COMPRESSOR AND MAGNETIC CLUTCH
- For 2WD:
  Refer to INSTALLATION [04/2013 - 08/2015] , or refer to INSTALLATION [08/2015 - 10/2017]
- For AWD:
  Refer to INSTALLATION [04/2013 - 08/2015] , or refer to INSTALLATION [08/2015 - 10/2017]