LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2015 >> IS 250 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Control System (2GR-FSE) - Service Information) >> Engine Coolant Temperature Sensor >> Removal [04/2013 - 10/2017] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal [04/2013 - 10/2017]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 Lexus IS 350, 2017 Lexus IS 300, 2016 Lexus IS 350, 2016 Lexus IS 300, and 2015 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FUEL PRESSURE SENSOR 

    Refer to REMOVAL [04/2013 - 10/2017]

  2. DISCONNECT WATER BY-PASS HOSE 
    1. Slide the clip and disconnect the water by-pass hose from the rear water by-pass joint.
      GTY404326Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
    2. Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor from the rear water by-pass joint.
      GTY396321Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the gasket from the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals