LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2015 >> IS 350 Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Lin Communication System - Diagnostics - Introduction >> Lin Communication System >> Data List / Active Test [04/2013 - ] >> Data List / Active Test [04/2013 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test [04/2013 - ]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Main Body / Data List.
    5. Read the Data List according to the display on the Techstream.

      Body Electrical > Main Body > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Communication D-Door Motor Connection status between power window regulator motor assembly (for driver door) and main body ECU (multiplex network body ECU) OK or STOP OK: Connected
      STOP: Not Connected      		 DTC is output if an error occurs in LIN communication.
      Communication P-Door Motor Connection status between power window regulator motor assembly (for front passenger door) and main body ECU (multiplex network body ECU) OK or STOP OK: Connected
      STOP: Not Connected      		 DTC is output if an error occurs in LIN communication.
      Communication RR-Door Motor Connection status between power window regulator motor assembly (for rear RH door) and main body ECU (multiplex network body ECU) OK or STOP OK: Connected
      STOP: Not Connected      		 DTC is output if an error occurs in LIN communication.
      Communication RL-Door Motor Connection status between power window regulator motor assembly (for rear LH door) and main body ECU (multiplex network body ECU) OK or STOP OK: Connected
      STOP: Not Connected      		 DTC is output if an error occurs in LIN communication.
      Communication Slide Roof Connection status between sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (multiplex network body ECU)* OK or STOP OK: Connected
      STOP: Not Connected      		 DTC is output if an error occurs in LIN communication.
      Communication Master SW Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU) OK or STOP OK: Connected
      STOP: Not Connected      		 DTC is output if an error occurs in LIN communication.
      The Number of DTC Number of DTCs 0 to 255 Number of stored DTCs -
      1. *: w/ Sliding Roof System

      Body Electrical > Smart Access > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      # Codes Number of DTCs 0 to 255 Number of stored DTCs -
scientia non olet · About LEMON Manuals