Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) [04/2013 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location).

   Refer to INITIALIZATION [04/2013 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Check that each power window moves when the auto up and down function of the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly is operated.

   Refer to OPERATION CHECK [04/2013 - ]

   OK

   Auto up and down function is normal (applicable location).

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Remove the window regulator.
2. Install the window glass to the door glass run.
3. Check if the door window regulator operates smoothly.
4. Check that the window glass slides smoothly when sliding it up by hand.
   WARNING:

   Perform initialization again.

   HINT: 

   Ensure the following: 

   • The window glass fits with the glass run without improper contact or deformation.
   • Foreign matter is not caught in the glass run.

   OK

   Door window glass slides smoothly.

   Result

   Result	Proceed to
   OK (Driver door power window)	A
   OK (Front passenger door power window)
   OK (Rear LH door power window)	B
   OK (Rear RH door power window)
   NG	C

Result: 

A 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR). Refer to  REMOVAL [04/2013 - ] 

Result: 

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR OR REAR RH DOOR). Refer to  REMOVAL [04/2013 - ] 

Result: 

C 

FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS)