DTC C1A10: Front Radar Sensor [04/2013 - 10/2016]: Procedure

1. Replace the millimeter wave radar sensor assembly with a new one.

   Refer to REMOVAL [04/2013 - 10/2016]

2. Perform millimeter wave radar sensor assembly adjustment.

   Refer to ADJUSTMENT [04/2013 - 10/2016]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [04/2013 - 10/2016]

   Body Electrical > Pre-Collision 2 > Clear DTCs 

2. Make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [04/2013 - 10/2016]

   Body Electrical > Pre-Collision 2 > Trouble Codes 

   NOTE:

   When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

   Result

   Result	Proceed to
   DTC C1A10 is not output	A
   DTC C1A10 is output	B

Result: 

A 

END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE) 

Result: 

B 

REPLACE DRIVING SUPPORT ECU ASSEMBLY. Refer to  REMOVAL [04/2013 - 09/2020]