Problem Symptoms Table [10/2014 - 09/2017]
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.
- When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
- When replacing the combination meter assembly, make sure to replace it with a new one.
- After replacing the brake actuator assembly (skid control ECU), perform linear valve offset learning and yaw rate sensor and G sensor zero point calibration.
DYNAMIC RADAR CRUISE CONTROL SYSTEM
| Symptom | Suspected Area | Link |
|---|---|---|
| The cruise control main switch cannot be turned on. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Cruise control switch circuit | Refer to Cruise Control Switch Circuit [10/2014 - 09/2017] | |
| Cruise main indicator light circuit | Refer to Cruise Main Indicator Light Circuit [10/2014 - 09/2017] | |
| Combination meter assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Switching using the MODE switch is not possible. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Cruise control switch circuit | Refer to Cruise Control Switch Circuit [10/2014 - 09/2017] | |
| Combination meter assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Switching using the vehicle-to-vehicle switch is not possible. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Distance control switch circuit | Refer to Distance Control Switch Circuit [10/2014 - 09/2017] | |
| Combination meter assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Cannot set in the constant speed control mode. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Vehicle stability control system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 05/2019] | |
| Automatic transaxle system (for U661E) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Automatic transaxle system (for U661F) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Cruise control switch circuit | Refer to Cruise Control Switch Circuit [10/2014 - 09/2017] | |
| Stop light switch circuit | Refer to DTC C1A4B: Stop Light Relay Circuit [10/2014 - 09/2017] | |
| Integration control and panel assembly | Refer to REMOVAL [10/2014 - ] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Cannot set in the vehicle-to-vehicle distance control mode. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Vehicle stability control system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 05/2019] | |
| Automatic transaxle system (for U661E) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Automatic transaxle system (for U661F) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Millimeter wave radar sensor assembly is dirty | - | |
| Millimeter wave radar sensor assembly beam axis not adjusted | Refer to ADJUSTMENT [10/2014 - 09/2017] | |
| Cruise control switch circuit | Refer to Cruise Control Switch Circuit [10/2014 - 09/2017] | |
| Wiper signal circuit | Refer to Wiper Signal Circuit [10/2014 - 09/2017] | |
| Millimeter wave radar sensor assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Integration control and panel assembly | Refer to REMOVAL [10/2014 - ] | |
| Combination meter assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Canceled during constant speed control. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Vehicle stability control system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 05/2019] | |
| Automatic transaxle system (for U661E) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Automatic transaxle system (for U661F) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Cruise control switch circuit | Refer to Cruise Control Switch Circuit [10/2014 - 09/2017] | |
| Stop light switch circuit | Refer to DTC C1A4B: Stop Light Relay Circuit [10/2014 - 09/2017] | |
| Integration control and panel assembly | Refer to REMOVAL [10/2014 - ] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Canceled during vehicle-to-vehicle control. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Vehicle stability control system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 05/2019] | |
| Millimeter wave radar sensor assembly is dirty | - | |
| Millimeter wave radar sensor assembly beam axis not adjusted | Refer to ADJUSTMENT [10/2014 - 09/2017] | |
| Cruise control switch circuit | Refer to Cruise Control Switch Circuit [10/2014 - 09/2017] | |
| Wiper signal circuit | Refer to Wiper Signal Circuit [10/2014 - 09/2017] | |
| Automatic transaxle system (for U661E) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Automatic transaxle system (for U661F) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Millimeter wave radar sensor assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Integration control and panel assembly | Refer to REMOVAL [10/2014 - ] | |
| Combination meter assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Hunting (vehicle speed does not stabilize) during constant speed control. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Vehicle stability control system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 05/2019] | |
| Millimeter wave radar sensor assembly is dirty | - | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Hunting (vehicle speed does not stabilize) during vehicle-to-vehicle control. | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Vehicle stability control system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 05/2019] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Cannot cancel by CANCEL switch operation. | Cruise control switch circuit | Refer to Cruise Control Switch Circuit [10/2014 - 09/2017] |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Cannot cancel by shift lever or transmission shift switch operation. | Automatic transaxle system (for U661E) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] |
| Automatic transaxle system (for U661F) | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] | |
| Shift lock control unit assembly (for U661E) | Refer to REMOVAL [10/2014 - ] | |
| Shift lock control unit assembly (for U661F) | Refer to REMOVAL [10/2014 - ] | |
| Park/Neutral position sensor (for U661E) | Refer to REMOVAL [10/2014 - ] | |
| Park/Neutral position sensor (for U661F) | Refer to REMOVAL [10/2014 - ] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Cannot cancel by brake operation. | Stop light switch circuit | Refer to DTC C1A4B: Stop Light Relay Circuit [10/2014 - 09/2017] |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Cannot cancel by wiper HI operation. | Wiper signal circuit | Refer to Wiper Signal Circuit [10/2014 - 09/2017] |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Control cannot be canceled while vehicle is stopped. | Seat belt warning system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] |
| Theft deterrent system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] | |
| Door courtesy switch circuit | Refer to Door Courtesy Switch Circuit [10/2014 - ] | |
| Back door courtesy switch circuit | Refer to Back Door Courtesy Switch Circuit [10/2014 - 05/2019] | |
| Even though the millimeter wave radar sensor is not dirty, "Clean Sensor" is displayed. | Millimeter wave radar sensor assembly | Refer to REMOVAL [10/2014 - 09/2017] |
| The warning buzzer does not sound. | Skid control buzzer circuit | Refer to DTC C1A4A: Skid Control Buzzer Circuit [10/2014 - 09/2017] |
| Check millimeter wave radar sensor assembly installation position | Refer to INSTALLATION [10/2014 - 09/2017] | |
| Millimeter wave radar sensor assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Even though the proximity warning buzzer sounds, brake control is not performed (when decelerating). | CAN communication system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] |
| Vehicle stability control system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 05/2019] | |
| ECM | Refer to REMOVAL [10/2014 - 05/2019] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Cruise control SET indicator light is not displayed (during cruise control). | Cruise set indicator light circuit | Refer to Cruise SET Indicator Light Circuit [10/2014 - 09/2017] |
| Combination meter assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] | |
| Cruise control indicator light continues to display. | Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] |
| Nothing displayed on the multi-information display in combination meter assembly. | Combination meter assembly | Refer to REMOVAL [10/2014 - 09/2017] |
| Even though cruise control system is canceled, buzzer does not sound. | Combination meter assembly | Refer to REMOVAL [10/2014 - 09/2017] |
| Even though the electric parking brake is operating, control cannot be canceled (w/ Full-speed Following Function). | Parking brake ECU assembly | Refer to REMOVAL [10/2014 - 05/2019] |
| Driving support ECU assembly | Refer to REMOVAL [10/2014 - 09/2017] |