Key-off Operation Function Operates even if Operating Conditions are not Satisfied [03/2014 - ]: Procedure
- CHECK MANUAL UP / DOWN FUNCTION
- Check that the manual up/down function using the multiplex network master switch assembly and power window regulator switch assembly can operate all the power windows. Refer to OPERATION CHECK [03/2014 - ]
.
OK
Manual up/down function is normal.
NG → See step 7
OK: Go to next step
- Check that the manual up/down function using the multiplex network master switch assembly and power window regulator switch assembly can operate all the power windows. Refer to OPERATION CHECK [03/2014 - ]
.
- CHECK REMOTE UP / DOWN FUNCTION
- Check that the remote up/down function using the multiplex network master switch assembly operates the power windows. Refer to OPERATION CHECK [03/2014 - ]
).
OK
Remote up/down function is normal.
NG → See step 7
OK: Go to next step
- Check that the remote up/down function using the multiplex network master switch assembly operates the power windows. Refer to OPERATION CHECK [03/2014 - ]
).
- CHECK OPERATION FUNCTION AFTER ENGINE SWITCH IS TURNED OFF
- Check the power window operation function after the engine switch is turned off.
Result
Result Proceed to When power window can still be operated even after opening driver side door or front passenger side door within approximately 45 seconds of engine switch being turned off A When power window can still be operated even after approximately 45 seconds have elapsed after engine switch is turned off (for All Doors) B When power window can still be operated even after approximately 45 seconds have elapsed after engine switch is turned off (for Driver Side, Front Passenger Side, Rear LH Side or Rear RH Side)) C* HINT:
*: Replace the power window regulator motor assembly. Refer to REMOVAL [03/2014 - ] for Front Door. Refer to REMOVAL [03/2014 - ] for Rear Door) for the window that still operates when more than 45 seconds have elapsed after the engine switch was turned off.
B → See step 6
C → REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (APPLICABLE LOCATION)
A: Go to next step
- Check the power window operation function after the engine switch is turned off.
- READ VALUE USING TECHSTREAM (Main Body)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Data List.
- Read the Data List according to the display on the Techstream.MAIN BODY (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door Courtesy SW Driver side door courtesy switch signal / ON or OFF ON: Driver side door open
OFF: Driver side door closed- P Door Courtesy SW Front passenger side door courtesy switch signal / ON or OFF ON: Front passenger side door open
OFF: Front passenger side door closed- OK
On the Techstream screen, ON or OFF is displayed accordingly.
NG → See step 5
OK → See step 6
- GO TO LIGHTING SYSTEM (Proceed to Door Courtesy Light Switch Circuit). Refer to Door Courtesy Switch Circuit [03/2014 - ]
- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to REMOVAL [03/2014 - ]
- GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to PROBLEM SYMPTOMS TABLE [03/2014 - ]