DTC C1A46: Yaw Rate Sensor [03/2014 - ]: Procedure

CHECK DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
1. Check DTCs for vehicle stability control system. Refer to DTC CHECK / CLEAR [03/2014 - ] .
  OK
  
  DTC C1435 is not output.
NG → See step 3

OK: Go to next step
CHECK DTC OUTPUT (PRE-COLLISION SYSTEM)
1. Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
2. Clear the DTCs. Refer to DTC CHECK / CLEAR [03/2014 - ] .
3. Drive the vehicle.
4. Recheck for DTCs.
  OK
  
  DTC C1A46 is not output.
NG → See step 4

OK → See step 5
GO TO VEHICLE STABILITY CONTROL SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2014 - ]
REPLACE DRIVING SUPPORT ECU. Refer to REMOVAL [03/2014 - ]
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION). Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2014 - ]