Jam Protection Function does not Operate [08/2014 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location) (See article. Refer to INITIALIZATION [08/2014 - 08/2015] Refer to INITIALIZATION [08/2015 - ] ).

Result:  NEXT

NEXT 

See step  2

1. Check if the power window auto up and down functions operate normally (See article. Refer to OPERATION CHECK [08/2014 - 08/2015] Refer to OPERATION CHECK [08/2015 - ] ).

   OK

   Auto up and down functions are normal.

Result:  NG

NG 

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) 

(See article. Refer to PROBLEM SYMPTOMS TABLE [08/2014 - 08/2015] Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] )

Result:  OK

OK 

See step  3

1. Check if the jam protection function operates normally for the applicable power window.

   HINT: 

   The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

   OK

   Jam protection function operates normally.

   Result

   Result	Proceed to
   OK	A
   NG (Driver door power window)	B
   NG (Front passenger side power window)	B
   NG (Rear LH side power window)	C
   NG (Rear RH side power window)	C

Result:  A

A 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result:  B

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side or Front Passenger Side) 

(See article. Refer to REMOVAL [08/2014 - ] )

Result:  C

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side or Rear RH Side) 

(See article. Refer to REMOVAL [08/2014 - ] )