DTC B2313: Glass Position Initialization Incomplete [07/2015 - ]: Procedure

1. Turn the power switch on (IG).
2. Initialize the power window regulator motor assembly. Refer to INITIALIZATION [07/2015 - ]

   HINT: 

   Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.

Result:  NEXT

NEXT 

See step  2

1. Turn the power switch off.
2. Wait for at least 10 seconds, and then turn the power switch on (IG).
3. Check for DTCs. Refer to DTC CHECK / CLEAR [07/2015 - ]

   HINT: 

   Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.

   OK

   DTC B2313 is not output.

   Result

   Result	Proceed to
   OK	A
   NG (Driver door power window)	B
   NG (Front passenger door power window)	B
   NG (Rear LH door power window)	C
   NG (Rear RH door power window)	C

Result:  A

A 

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED) 

Result:  B

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR) 

Refer to REMOVAL [07/2015 - ]

Result:  C

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR OR REAR RH DOOR) 

Refer to REMOVAL [07/2015 - ]