Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated) [07/2015 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location). Refer to INITIALIZATION [07/2015 - ]

Result:  NEXT

NEXT 

See step  2

1. Check that each power window moves when the auto up and down function of the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly is operated. Refer to INITIALIZATION [07/2015 - ]

   OK

   Auto up and down functions are normal (applicable location).

Result:  OK

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result:  NG

NG 

See step  3

1. Remove the power window.
2. Install the window glass to the door glass run.
3. Check if the door window regulator operates smoothly.
4. Check that the window glass slides smoothly when sliding it down by hand.

   OK

   Door window glass slides smoothly.

   Result

   Result	Proceed to
   NG	A
   OK (Driver door power window)	B
   OK (Front passenger door power window)	B
   OK (Rear LH door power window)	C
   OK (Rear RH door power window)	C

   HINT: 

   Ensure the following:

   • The window glass fits in the glass run without improper contact or deformation.
   • Foreign matter is not caught in the glass run.
   • The window glass run is not misaligned.
   • The window glass is not tilted and does not catch on the belt moulding or inner weatherstrip.
   WARNING:

   Perform initialization again.

Result:  A

A 

FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE) 

Result:  B

B 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR) 

Refer to REMOVAL [07/2015 - ]

Result:  C

C 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR OR REAR RH DOOR) 

Refer to REMOVAL [07/2015 - ]