How To Proceed With Troubleshooting [09/2014 - 10/2015]: Procedure

Result

Result: 

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, replace or recharge the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 10/2015] 

Result: 

A 

See step  4

1. Use the Techstream to check if the LIN communication system is functioning normally.

   Result

   Result	Proceed to
   LIN DTC is not output	A
   LIN DTC is output	B

Result: 

B 

GO TO LIN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - ] )

Result: 

A 

See step  5

1. Check for DTC (Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] ).
2. Clear the DTC (Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] ).
3. Recheck for DTC (Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] ).

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2014 - 10/2015] )

Result: 

A 

See step  6

1. Refer to the problem symptoms table (Refer to PROBLEM SYMPTOMS TABLE [09/2014 - 10/2015] ).

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

A 

See step  7

1. Operation Check (Refer to OPERATION CHECK [09/2014 - 10/2015] ).
2. Terminals of ECU (Refer to TERMINALS OF ECU [09/2014 - 10/2015] ).
3. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [09/2014 - 10/2015] ).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

See step  9

Result

Result: 

NEXT 

END