Precaution [09/2017 - ]
- PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
After the engine switch is turned off, multi-media module receiver assembly requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- If the cable has been disconnected from the negative (-) battery terminal, it is necessary to initialize the system. To initialize the system, perform the following procedures:
- Move the vehicle to an open area with good GPS reception.
HINT:
The GPS icon is displayed on the map screen when the reception is good.
- Turn the engine switch on (IG), and then wait several minutes while the system acquires time and location data and activates Destination Assist.
- Move the vehicle to an open area with good GPS reception.
- If the cable has been disconnected from the negative (-) battery terminal, it is necessary to initialize the system. To initialize the system, perform the following procedures:
- PRECAUTION FOR REGISTRATION
- If replacing any of the following parts, refer to Registration (Refer to REGISTRATION [10/2015 - ]
).
- DCM (telematics transceiver)
- If replacing any of the following parts, refer to Registration (Refer to REGISTRATION [10/2015 - ]
).