Customize Parameters [09/2014 - ]: Procedure

HINT: 

The following items can be customized.

1. Customizing with the Techstream
   1. Connect the Techstream to the DLC3.
   2. Turn the power switch on (IG).
   3. Turn the Techstream on.
   4. Enter the following menus: Customize / Smart Key/Access or Warning.
   5. Select the setting by referring to the table below.
      SMART KEY/ACCESS
      
      

      Display	Default	Content	Setting	Relevant ECU
      Ignition Available Area (Entry ignition available area)	All	Function that sets the area that the key must be in before the power switch can be operated.	Front or All	Certification ECU (smart key ECU assembly)
      Engine Start Indicator	ON	Function that turns the smart warning light on the combination meter assembly on or off.	OFF or ON

      WARNING
      
      

      Display	Default	Content	Setting	Relevant ECU
      Key Low Battery Warning (Warn when key battery becomes weak)	ON	Enables or disables the sounding of the buzzer when the transmitter battery is low and the power switch is turned off after being on (IG) for 20 minutes or more.	OFF or ON	Certification ECU (smart key ECU assembly)

2. Entry cancel function (manual operation)

   HINT: 

   While the smart access system with push-button start is canceled, it is possible to lock and unlock the doors with the wireless operation, and the start system can be operated by holding the electrical key transmitter sub-assembly near the power switch.

   1. The following functions are disabled when the smart access system with push-button start is canceled.
      1. Entry unlock/lock functions
      2. Entry luggage compartment door open function
      3. Push-button start function
      4. Key lock-in prevention function
      5. Entry warning functions
   2. When canceling the system through manual operation:
      1. Make sure the following conditions are met:
         • The power switch is off.
         • The driver door is closed.
         • The driver door is unlocked.
      2. Press the unlock switch of the electrical key transmitter sub-assembly.
      3. Open the driver door within 5 seconds of completing the step above (driver door: close condition → opened).
      4. With the driver door open, press the unlock switch of the electrical key transmitter sub-assembly 2 times within 5 seconds of completing the step above.
         NOTE:

         If the driver door is closed before or while pressing the unlock switch, the entry cancel setting mode will end.

      5. Close and open the driver door twice completing the above step (driver door: open condition → closed → opened → closed → opened).
      6. With the driver door open, press the unlock switch of the electrical key transmitter sub-assembly 2 times completing the step above.
         NOTE:

         If the driver door is closed before or while pressing the unlock switch, the entry cancel setting mode will end.

      7. Close and open the driver door completing the step above (driver door: open condition → closed → opened).
      8. Close the driver door within 5 seconds of completing the above step.
      9. Check that the wireless buzzer sounds twice (short beeps) to confirm that the smart access system with push-button start has been canceled.

      HINT: 

      Finish steps 5 to 7 within 30 seconds.

   3. Perform the following procedure to restore the smart access system with push-button start to the active state from the canceled state.
      1. Perform the procedures to cancel the smart access system with push-button start again.
      2. Check that the wireless buzzer sounds once (short beep) to confirm that the smart access system with push-button start has been restored to the active state.

         HINT: 

         • The system changes between the canceled state and the active state each time the procedure to cancel the system through manual operation is performed.
         • The buzzer sounds twice when the system changes from the active state to the canceled state, and sounds once when the system changes from the canceled state to the active state.