LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2016 >> IS 200t Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Four Wheel Drive Control System - Diagnostics - Introduction) >> Four Wheel Drive Control System >> Initialization [04/2013 - ] >> Initialization [04/2013 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Initialization [04/2013 - ]

WARNING: This page does not describe the selected car, but rather 22 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DESCRIPTION 
    1. When the 4WD ECU assembly is replaced with a normal one from another vehicle, it is necessary to perform initialization.
      NOTE:
      • If initialization is not performed, it may affect AWD initial performance (acceleration, etc.).
      • When the yaw rate sensor (G sensor) is replaced, it is necessary to perform initialization.

      HINT: 

      When the 4WD ECU assembly is replaced with a new one, it is not necessary to perform initialization.

  2. PERFORM INITIALIZATION 
    1. Turn the engine switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the engine switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Chassis / Four Wheel Drive / Utility / Reset Memory.

      Chassis > Four Wheel Drive > Utility 

      Tester Display
      Reset Memory
    6. Operate the Techstream to clear the data.
scientia non olet · About LEMON Manuals