Service Data [04/2013 - 10/2017]
| Starter assembly | Standard current: 90 A or less at 11.5 V | |
| Starter magnetic switch assembly | Standard resistance 50 - C: Below 1 Ω 50 - Body: Below 1 Ω |
|
| Starter armature assembly | Standard resistance Commutator: Below 1 Ω Commutator - Coil core: 10 kΩ or higher |
|
| Standard length: 3.1 mm (0.122 in.) | ||
| Maximum length: 3.8 mm (0.150 in.) | ||
| Starter commutator end frame | Standard length: 9.0 mm (0.354 in.) | |
| Minimum length: 4.0 mm (0.157 in.) | ||
| Standard resistance Positive (+) - Negative (-): 10 kΩ or higher |
||
| Snap ring | Maximum length: 5.0 mm (0.196 in.) | |
| Starter relay | 3 - 5: 10 kΩ or higher (when battery voltage not applied between terminals 1 and 2) 3 - 5: Below 1 Ω (when battery voltage applied between terminals 1 and 2) |
|
| Engine switch | 5 (SS1) - 6 (GND) / 1 (SS2) - 6 (GND) Specified resistance Not pushed: 10kΩ or higher Pushed: Below 1 Ω |
|
| Standard condition: Illuminates Measurement condition Battery positive (+) → Terminal 9 (SWIL) Battery negative (-) → Terminal 6 (GND) |
||
| Ignition or starter switch assembly | LOCK Between all terminals |
10 kΩ or higher |
| ACC 2 (ACC) - 4 (AM1) |
Below 1 Ω | |
| ON 2 (ACC) - 4 (AM1) 1 (IG1) - 4 (AM1) 5 (AM2) - 6 (IG2) |
||
| START 3 (ST1) - 4 (AM1) 1 (IG1) - 4 (AM1) 5 (AM2) - 6 (IG2) 5 (AM2) - 7 (ST2) |
||