Installation [04/2013 - 08/2015]: Procedure
WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [04/2013 - 08/2015]
- Install a new gasket onto the engine coolant temperature sensor.
- Using a 19 mm ball joint lock nut wrench, install the engine coolant temperature sensor to the rear water by-pass joint.
Torque: 19.6 N.m (200 kgf/cm, 14 ft.lbf)
NOTE:Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a ball joint lock nut wrench.
Refer to PRECAUTION [04/2013 - 08/2015]
- Connect the engine coolant temperature sensor connector.
- CONNECT WATER BY-PASS HOSE
- Connect the water by-pass hose to the rear water by-pass joint and slide the clip to secure it.
- INSTALL FUEL PRESSURE SENSOR
Refer to INSTALLATION [04/2013 - 08/2015]
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Refer to INITIALIZATION [04/2013 - 08/2015]
- Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.