DTC P062F: Internal Control Module EEPROM Error [04/2013 - 10/2017]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   HINT: 

   Write down the currently output DTCs before clearing them.

   Powertrain > ECT > Clear DTCs 

5. Turn the engine switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
8. Connect the cable to the negative (-) battery terminal.
9. Connect the Techstream to the DLC3.
10. Turn the engine switch on (IG).
11. Turn the Techstream on.
12. Enter the following menu items: Powertrain / ECT / Trouble Codes.

    Powertrain > ECT > Trouble Codes 

13. Read DTCs.

    Result

    Result	Proceed to
    DTCs are not output	A
    DTC P062F is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [04/2013 - 06/2014]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2014 - 08/2015]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 10/2016]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2016 - 10/2017] 

Result: 

B 

See step  2

1. Replace the TCM.

   Refer to COMPONENTS [04/2013 - 10/2017]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM A/T CODE REGISTRATION. Refer to  REGISTRATION [04/2013 - 10/2017]