How To Proceed With Troubleshooting [09/2015 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result:  1

NEXT 

See step  3

1. Using the Techstream, check the electric power control system's load control history.

   Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ]

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  4

1. Record DTCs and freeze frame data.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  5

Result

Result:  1

NEXT 

See step  6

Result

Result:  2

B 

See step  8

Result:  1

A 

See step  7

Result

Result:  1

NEXT 

See step  8

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

2. Delete DTCs.
3. Recheck for DTCs.

   Result

   Result	Proceed to
   DTC does not reoccur	A
   DTC reoccurs	B

   HINT: 

   • Refer to the diagnostic trouble code chart if any DTCs are output.
   • If any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.

     Refer to DIAGNOSIS SYSTEM [09/2015 - ]

   • If communication to the power steering ECU is not established through the Techstream, inspect terminals CANH and CANL of the DLC3 and power steering ECU, and inspect the IG circuit of the power steering ECU.

Result:  2

B 

See step  10

Result:  1

A 

See step  9

Result

Result:  1

NEXT 

See step  10

Result

Result:  1

NEXT 

See step  11

Result

Result:  1

NEXT 

See step  12

Result

Result:  1

NEXT 

See step  13

Result

Result:  1

NEXT 

END