Installation [09/2015 - ]: Procedure
- INSTALL OBJECT RECOGNITION CAMERA NOTE:
- Do not touch the camera lens when removing or installing the camera.
- Do not use a camera which has been dropped or subjected to an impact.
- If the camera is not installed securely, the system may not operate properly. Therefore, be sure to install the camera securely.
- Push the bracket to attach the clip.
- Allow the wire harness to hang down.
- Do not press the sensor, as it may become deformed.
- Temporarily install the object recognition camera with the clip.
- Install the 3 bolts in alphabetical order.
Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
- Attach the claw to connect the connector clamp.
- Attach the 2 wire harness clamps.
- Connect the 3 connectors.TEXT IN ILLUSTRATION
*A w/o Night View System *B w/ Night View System - Return the roof headlining to its original position.
- INSTALL INNER REAR VIEW MIRROR ASSEMBLY
Refer to PROCEDURE - Step 1
- INSTALL RAIN SENSOR COVER
Refer to PROCEDURE - Step 2
- INSTALL VISOR HOLDER
Refer to PROCEDURE - Step 11
- INSTALL VISOR ASSEMBLY LH
Refer to PROCEDURE - Step 12
- INSTALL VISOR ASSEMBLY RH
Refer to PROCEDURE - Step 13
- INSTALL VISOR BRACKET COVER
Refer to PROCEDURE - Step 14
- INSTALL MAP LIGHT ASSEMBLY
Refer to PROCEDURE - Step 24
- ADJUST OBJECT RECOGNITION CAMERA
Refer to 1
- ADJUST NIGHT VIEW CAMERA (w/ Night View System:)
Refer to ADJUSTMENT [09/2015 - ] )