DTC P060A: Internal Control Module Monitoring Processor Performance [09/2015 - ]: Procedure

CHECK DTC
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs (Refer to DTC CHECK / CLEAR [09/2015 - ] ).
5. Turn the power switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
8. Connect the cable to the negative (-) auxiliary battery terminal.
9. Connect the Techstream to the DLC3.
10. Turn the power switch on (IG).
11. Turn the Techstream on.
12. Wait 16 seconds or more.
13. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
14. Check DTC.
  OK
  
  P060A is not stored.
Result: OK

OK

CHECK FOR INTERMITTENT PROBLEMS

(Refer to CHECK FOR INTERMITTENT PROBLEMS [09/2015 - ] )

Result: NG

NG

REPLACE ECM

(Refer to REMOVAL [09/2015 - ] )