Installation [09/2014 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL TRANSFER TRANSMISSION WIRE
- Coat the transfer transmission wire O-ring with ATF.
*a Transfer Transmission Wire O-ring Coat with Toyota Genuine ATF WS ATF
Toyota Genuine ATF WS
- Install the transfer transmission wire to the transfer case sub-assembly with the bolt.
Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf)
- Connect the transfer control solenoid assembly connector.
- Coat the transfer transmission wire O-ring with ATF.
- INSTALL TRANSFER CONTROL VALVE BODY ASSEMBLY
Refer to INSTALLATION [09/2014 - ]