Utility [07/2015 - ]

NOTE:

If the forward recognition camera has been replaced or removed/installed, perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust. If not performed, DTC C1AA9 will be stored when the system is turned on.
When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Lexus genuine part. If a non-Lexus genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket or the front recognition camera system may not operate properly due to a difference in the transmissivity or black ceramic border.

Recognition Camera/Target Position Memory
1. Perform Recognition Camera Axis Adjust according to the display on the Techstream. Refer to ADJUSTMENT [07/2015 - ]
  HINT:
  
  Before performing "Recognition Camera Axis Adjust", store the recognition camera position information, target position information and vehicle information in the forward recognition camera.
Recognition Camera Axis Adjust
1. Perform Recognition Camera Axis Adjust according to the display on the Techstream. Refer to ADJUSTMENT [07/2015 - ]
  HINT:
  
  After performing the "Recognition Camera/Target Position Memory", further calibrate the stored data.
History Clear
HINT:

If any history DTCs for the forward recognition camera are stored, clear them according to the following procedure.
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / front recognition camera / Utility / History Clear.
5. Perform History Clear according to the display on the Techstream.
PCS Image Information Clear
HINT:

PCS Image Information Clear is used to clear the PCS Image Information data.
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / front recognition camera / Utility / PCS Image Information Clear.
5. Perform PCS Image Information Clear according to the display on the Techstream.
PCS Image Record Setting
HINT:

PCS Image Record Setting is used to activate/deactivate the PCS image recording function.
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / front recognition camera / Utility / PCS Image Record Setting.
5. Perform PCS Image Record Setting according to the display on the Techstream.