Installation [09/2014 - 10/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus GS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE COOLANT TEMPERATURE SENSOR
1. Install a new gasket to the engine coolant temperature sensor.
2. Install the engine coolant temperature sensor.
  Torque: 20 N*m (200 kgf*cm, 14 ft.*lbf)
  
  HINT:
  
  Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor (Refer to INITIALIZATION [09/2014 - 10/2015] ).
3. Connect the engine coolant temperature sensor connector.
CONNECT WATER BY-PASS HOSE
1. Connect the water by-pass hose to the rear water by-pass joint.
INSTALL FUEL PRESSURE SENSOR
(Refer to INSTALLATION [09/2014 - 10/2015] )