How To Proceed With Troubleshooting [09/2014 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN Communication System is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 10/2015] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )

Result: 

A 

See step  4

Result

Result: 

NEXT 

See step  5

1. Check for DTCs (Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] , or refer to DTC CHECK / CLEAR [10/2015 - ] ).
2. Clear the DTCs (Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] , or refer to DTC CHECK / CLEAR [10/2015 - ] ).
3. Recheck for DTCs (Refer to DTC CHECK / CLEAR [09/2014 - 10/2015] , or refer to DTC CHECK / CLEAR [10/2015 - ] ).

   Result

   Result	Proceed to
   DTC does not reoccur	A
   DTC reoccurs	B

Result: 

B 

See step  8

Result: 

A 

See step  6

1. Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [09/2014 - 10/2015] , or refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] ).

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

Result: 

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

A 

See step  7

1. Terminals of ECM (Refer to TERMINALS OF ECM [09/2014 - 10/2015] , or refer to TERMINALS OF ECM [10/2015 - ] ).
2. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [09/2014 - 10/2015] , or refer to DATA LIST / ACTIVE TEST [10/2015 - ] ).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

See step  9

Result

Result: 

NEXT 

END