Data List / Active Test [09/2014 - ]

HINT: 

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

1. Connect the Techstream to the DLC3.
2. Turn the power switch to on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List / All Data.
5. According to the display on the Techstream, read the Data List.
   MAIN BODY
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Communication D-Door Motor	Connection status between front power window regulator motor assembly LH and main body ECU (multiplex network body ECU) / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
   Communication P-Door Motor	Connection status between front power window regulator motor assembly RH and main body ECU (multiplex network body ECU) / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
   Communication RR-Door Motor	Connection status between rear power window regulator motor assembly RH and main body ECU (multiplex network body ECU) / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
   Communication RL-Door Motor	Connection status between rear power window regulator motor assembly LH and main body ECU (multiplex network body ECU) / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
   Communication Slide Roof	Connection status between sliding roof drive gear sub-assembly and main body ECU (multiplex network body ECU) / OK or STOP	OK: Connection STOP: No connection	w/ Sliding Roof System When there is a malfunction, a DTC is stored. w/o Sliding Roof System "STOP" is always displayed as there is no connection to the LIN communication system.
   Communication Master SW	Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU) / OK or STOP	OK: Connection STOP: No connection	When there is a malfunction, a DTC is stored.
   The Number of DTC	Number of trouble codes / Min.: 0, Max.: 255	Number of stored DTCs	-

   NOTE:

   When the Techstream display is changed to "All Data", items that are not applicable to the vehicle may be displayed.