Installation [09/2014 - ]: Procedure

INSTALL STEERING CONTROL ECU
1. Install the steering control ECU with the 2 bolts.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
2. Connect the 4 connectors.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 17 Refer to PROCEDURE - Step 16
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 18 Refer to PROCEDURE - Step 17
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 29 Refer to PROCEDURE - Step 28
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See article. Refer to INITIALIZATION [09/2014 - 10/2015] Refer to INITIALIZATION [10/2015 - ] ).
INSTALL LUGGAGE COMPARTMENT TRIM COVER LH
Refer to PROCEDURE - Step 24
INSTALL LUGGAGE COMPARTMENT FLOOR MAT
Refer to PROCEDURE - Step 26
PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION
(See article. Refer to CALIBRATION [09/2014 - ] )
PERFORM INITIALIZATION
(See article. Refer to INITIALIZATION [09/2014 - ] )