How To Proceed With Troubleshooting [08/2015 - 08/2019]: Procedure

Result

Result: 

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION. Refer to  DIAGNOSIS SYSTEM [08/2015 - 08/2019] 

Result: 

A 

See step  4

1. Check for DTC (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
2. Clear the DTC (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the dynamic radar cruise control system DTCs by simulating the conditions indicated by the DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019] )

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019] ).

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Operation Check (Refer to OPERATION CHECK [08/2015 - 08/2019] ).
2. Terminals of ECU (Refer to TERMINALS OF ECU [08/2015 - 08/2019] ).
3. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019] ).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END