DTC Check / Clear [04/2013 - 09/2020]

CHECK DTC
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the blind spot monitor main switch (warning canceling switch assembly) on.
4. Turn the Techstream on.
5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.
  HINT:
  
  The blind spot monitor sensor RH and the blind spot monitor sensor LH both output DTCs. Therefore, check both blind spot monitor sensors for DTCs.
  
  Body Electrical > Blind Spot Monitor Master > Trouble Codes
  
  Body Electrical > Blind Spot Monitor Slave > Trouble Codes
6. Check for DTCs.
  Refer to DIAGNOSTIC TROUBLE CODE CHART [04/2013 - 10/2016] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2016 - 09/2020]
CLEAR DTC
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the blind spot monitor main switch (warning canceling switch assembly) on.
4. Turn the Techstream on.
5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.
  Body Electrical > Blind Spot Monitor Master > Clear DTCs
  
  Body Electrical > Blind Spot Monitor Slave > Clear DTCs
6. Clear the DTCs.