Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH [04/2013 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / RL-Door Motor / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > RL-Door Motor > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   RL Door P/W Auto SW	Rear LH door power window auto switch signal	OFF or ON	OFF: Rear LH door power window auto switch not being operated ON: Rear LH door power window auto switch being operated	-

   Body Electrical > RL-Door Motor > Data List 

   Tester Display
   RL Door P/W Auto SW

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  4

Result: 

OK 

See step  2

1. Initialize the power window regulator motor assembly (for rear LH door).

   Refer to INITIALIZATION [04/2013 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Check that the rear LH door power window moves when the auto up and down function of the rear power window regulator switch assembly (for LH door) is operated.

   Refer to OPERATION CHECK [04/2013 - ]

   OK

   Rear LH door auto up and down function is normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR). Refer to  REMOVAL [04/2013 - ] 

1. Remove the rear power window regulator switch assembly (for LH door).

   Refer to REMOVAL [04/2013 - ]

2. Inspect the rear power window regulator switch assembly (for LH door).

   Refer to INSPECTION [04/2013 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR LH DOOR). Refer to  REMOVAL [04/2013 - ] 

Result: 

OK 

See step  5

1. Disconnect the O7 power window regulator motor assembly (for rear LH door) connector.
2. Measure the resistance according to the value(s) in the table below.
   STANDARD RESISTANCE
   
   

   Tester Connection	Condition	Specified Condition
   O8-4 (AUTO) - O7-4 (AUTO)	Always	Below 1 Ω
   O8-4 (AUTO) - Body ground	Always	10 kΩ or higher
   O7-4 (AUTO) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR). Refer to  REMOVAL [04/2013 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR