Installation [04/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL 4WD ECU ASSEMBLY
1. Install the 4WD ECU assembly to the blower assembly with the bolt.
  Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf)
2. Connect the 4WD ECU assembly connector.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 20 [04/2013 - 10/2016] , or refer to PROCEDURE - Step 21 [10/2016 - 10/2017] , or refer to PROCEDURE - Step 21 [10/2017 - 09/2020] , or refer to PROCEDURE - Step 20 [09/2020 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015] , or refer to INITIALIZATION [08/2015 - 10/2016] , or refer to INITIALIZATION [10/2016 - 10/2017] , or refer to INITIALIZATION [10/2017 - 09/2020] , or refer to INITIALIZATION [09/2020 - 11/2021] , or refer to INITIALIZATION [11/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]