How To Proceed With Troubleshooting [09/2015 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result:  1

NEXT 

See step  3

1. Using Techstream, check the electric power control system's load control history.

   Refer to OPERATION CHECK [09/2015 - ]

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  4

1. Check for DTCs.

   Refer to DIAGNOSIS SYSTEM [09/2015 - ]

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM 

Result:  1

A 

See step  5

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

2. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

3. Recheck for DTCs.

   Refer to DTC CHECK / CLEAR [09/2015 - ] 

   1. Simulate the malfunction and check if the DTCs are output again.

      Refer to DTC CHECK / CLEAR [09/2015 - ] 

   Result

   Result	Proceed to
   DTC is output	A
   DTC is not output	B
   DTCs are not output, and the malfunction cannot be simulated or checked.	C

Result:  2

B 

See step  10

Result:  3

C 

SYMPTOM SIMULATION 

Result:  1

A 

See step  6

Result

Result:  1

NEXT 

See step  7

Result

Result:  1

NEXT 

See step  8

Result

Result:  1

NEXT 

See step  9

Result

Result:  1

NEXT 

END 

Result

Result:  1

NEXT 

See step  11

Result

Result:  1

NEXT 

See step  12

Result

Result:  1

NEXT 

END