How To Proceed With Troubleshooting [09/2015 - ]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result: 1
NEXT
See step 2
- INSPECT BATTERY VOLTAGE
Standard Voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Result
Proceed to NEXT Result: 1
NEXT
See step 3
- CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
- Use the Techstream to check if the CAN communication system is functioning normally.
Result
Result Proceed to CAN DTC is not output A CAN DTC is output B
Result: 2
B
GO TO CAN COMMUNICATION SYSTEM
Result: 1
A
See step 4
- Use the Techstream to check if the CAN communication system is functioning normally.
- PROBLEM SYMPTOMS TABLE
Result
Result Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B Result: 2
B
See step 6
Result: 1
A
See step 5
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Data List / Active Test
Refer to DATA LIST / ACTIVE TEST [09/2015 - ]
- Terminals of ECU
Refer to TERMINALS OF ECU [09/2015 - ]
Result
Proceed to NEXT
Result: 1
NEXT
See step 6
- Data List / Active Test
- ADJUST, REPAIR OR REPLACE
Result
Proceed to NEXT Result: 1
NEXT
See step 7
- CONFIRMATION TEST
Result
Proceed to NEXT Result: 1
NEXT
END