DTC P0617: Starter Relay Circuit High [10/2015 - 11/2017]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Starter Signal.

   Powertrain > Engine > Data List 

   Tester Display
   Starter Signal

5. Check the value displayed on the Techstream when the vehicle is driven at 20 km/h (12.4 mph) or more.
   WARNING:

   When performing the confirmation driving pattern, obey all speed limits and traffic laws.

   Result

   Condition	Starter Signal	Proceed to
   Driving at 20 km/h (12.4 mph) or more	OFF	A
   	ON	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [09/2014 - 11/2017] 

Result: 

B 

See step  2

1. Inspect the park/neutral position switch assembly.

   for 2WD models: Refer to INSPECTION [09/2014 - ]

   for AWD models: Refer to INSPECTION [09/2014 - ]

   Result

   Result	Proceed to
   OK (for 2WD models)	A
   OK (for AWD models)	B
   NG	C

Result: 

B 

See step  4

Result: 

C 

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 

for 2WD models: Refer to REMOVAL [09/2014 - ]

for AWD models: Refer to REMOVAL [09/2014 - ]

Result: 

A 

See step  3

1. Repair or replace the harness or connector (park/neutral position switch assembly - ST NO. 1 relay - ECM - TCM - certification ECU (smart key ECU assembly)).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Repair or replace the harness or connector (park/neutral position switch assembly - ST NO. 1 relay - ECM - certification ECU (smart key ECU assembly)).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [09/2014 - 11/2017]

   Powertrain > Engine > Clear DTCs 

5. Turn the engine switch off and wait for at least 30 seconds.
6. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
8. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTC P0617 is output	A
   DTCs are not output	B

Result: 

B 

END 

Result: 

A 

See step  6

1. Check the smart access system with push-button start (for start function).

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - 11/2017]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [09/2014 - 11/2017] 

Result: 

NG 

REPAIR OR REPLACE SMART ACCESS SYSTEM WITH PUSH-BUTTON START