Customize Parameters [09/2014 - ]
- CUSTOMIZE BLIND SPOT MONITOR SYSTEM
- Customizing with the TechstreamNOTE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the blind spot monitor main switch (warning canceling switch assembly) on.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Warning.
- Select the setting by referring to the table below.
Warning
Tester Display Description Default Setting ECU RCTA Function Switches the RCTA function on and off. ON 0:ON, 1:OFF Blind Spot Monitor Sensor RH BSM Approaching Vehicle Detection Timing Setting Sets the notification timing for vehicles approaching from behind the vehicle. Middle 00:Only Blind Spot, 01:Late, 10:Middle, 11:Early Blind Spot Monitor Sensor LH
- Customizing with the Techstream