Operation Check [09/2014 - 10/2015]

INPUT SIGNAL CHECK

Fig 1: Input Signal Check
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Connect the Techstream to the DLC3.
2. Check the cruise control main switch (ON-OFF, CANCEL, -SET,+ RES, and MODE) using the DATA LIST function in the Techstream.

INSPECT MODE SWITCH

Turn the power switch on (IG).

Fig 2: Cruise Control Switch Mode Selection

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 3: Identifying Multi-Information Display & Indicator Lights

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Do not push any other switches before pushing the cruise control switch to MODE. If another switch is pushed, turn the main switch off and repeat the procedure above.

Turn the cruise control switch on. Then push the cruise control switch to MODE for 1 second or more to change to constant speed control mode. Check that "SET" is indicated on the multi-information display.

TEXT IN ILLUSTRATION

*1	Multi-information Display
*2	Cruise Control Indicator Light
*3	Cruise Control SET Indicator Light

HINT:

If a malfunction is detected, turn the engine switch off and repeat the procedure above.

INSPECT STEERING PAD SWITCH

Turn the power switch on (IG).
Turn the cruise control switch on. Then push the cruise control switch to MODE for 1 second or more to change to vehicle-to-vehicle distance control mode. Check that "RADAR READY" is indicated on the multi-information display.
Turn on the distance control switch of the steering pad switch.

Fig 4: Identifying Distance Control Switch
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEXT IN ILLUSTRATION

*1 Distance Control Switch

Check that the indication of the vehicle-to-vehicle distance, which is shown in the multi-information display on the combination meter, changes from long to middle to short in that order.

Fig 5: Screen Display - Vehicle-To-Vehicle Distance

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*1	Long
*2	Middle
*3	Short

HINT:

The indication is automatically set to long each time the power switch is turned on (READY).

HEADUP DISPLAY (w/ Headup Display)

Displays warning on the headup display only when the vehicle approach warning control is operating.

Fig 6: Identifying Vehicle Approach Warning (Warning Displayed Only During Warning Control) And Blinks

TEXT IN ILLUSTRATION

*1	Vehicle Approach Warning (Warning Displayed only During Warning Control)
*2	Blinks