LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2018 >> LC 500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Lighting System (Ext) - Service Information) >> Rear Combination Light Assembly >> Installation [09/2020 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation [09/2020 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2024 Lexus IS 500, 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 500, and 2023 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL REAR COMBINATION LIGHT LENS AND BODY 
  2. INSTALL REAR TURN SIGNAL LIGHT BULB 
    1. Install the rear turn signal light bulb to the rear combination light socket and wire.
    2. Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to connect them as a unit.
      GTY971800Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL REAR BUMPER UPPER RETAINER 
    1. Engage the 2 guides to install the rear bumper upper retainer.
      GTY970514Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL REAR COMBINATION LIGHT ASSEMBLY 
    1. Engage the grommet.
    2. Engage the guide and pin to temporarily install the rear combination light assembly as shown in the illustration.
      GTY971257Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Pin
      *b Guide
    3. Install the rear combination light assembly with the 4 screws.
    4. Remove the protective tape.
    5. Connect the connector.
  5. INSTALL LUGGAGE COMPARTMENT TRIM COVER 
    1. Install the luggage compartment trim cover to its original position as shown in the illustration.
      GTY971848Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 3 clips.
  6. INSTALL REAR BUMPER ASSEMBLY 

    Refer to INSTALLATION [09/2020 - ]

  7. INSTALL REAR COMBINATION LIGHT COVER 
    1. Engage the 3 claws as shown in the illustration.
      GTY971860Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Engage the 2 claws to install the rear combination light cover as shown in the illustration.
      GTY971859Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals