Key-off Operation Function Operates even if Operating Conditions are not Satisfied [09/2014 - ]: Procedure
- CHECK MANUAL UP / DOWN FUNCTION
- Check that the manual up and down functions using the multiplex network master switch assembly and power window regulator switch assembly can operate the power windows.
Refer to OPERATION CHECK [09/2014 - ]
OK
Manual up and down functions are normal.
Result
Proceed to OK NG
Result:
NG
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to PROBLEM SYMPTOMS TABLE [09/2014 - ]
Result:
OK
See step 2
- Check that the manual up and down functions using the multiplex network master switch assembly and power window regulator switch assembly can operate the power windows.
- CHECK REMOTE UP / DOWN FUNCTION
- Check that the remote up and down functions using the multiplex network master switch assembly can operate all of the power windows.
Refer to OPERATION CHECK [09/2014 - ]
OK
Remote up and down functions are normal.
Result
Proceed to OK NG
Result:
NG
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to PROBLEM SYMPTOMS TABLE [09/2014 - ]
Result:
OK
See step 3
- Check that the remote up and down functions using the multiplex network master switch assembly can operate all of the power windows.
- CHECK KEY-OFF OPERATION FUNCTION
- Check the key-off operation function.
Refer to OPERATION CHECK [09/2014 - ]
Result
Result Proceed to Power window can still be operated even after opening driver door or front passenger door within approximately 43 seconds of engine switch being turned off A Power window can still be operated even after approximately 43 seconds have elapsed since engine switch was turned off (for All Doors) B Power window can still be operated even after approximately 43 seconds have elapsed since engine switch was turned off (for Driver Door or Front Passenger Door) C
Result:
B
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to REMOVAL [09/2014 - ]
Result:
C
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR). Refer to REMOVAL [09/2014 - ]
Result:
A
See step 4
- Check the key-off operation function.
- READ VALUE USING TECHSTREAM (MAIN BODY)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Data List.
- Read the Data List according to the display on the Techstream.
Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note FR Door Courtesy SW Front door courtesy light switch assembly (for RH) signal OFF or ON OFF: Front door RH closed
ON: Front door RH open- FL Door Courtesy SW Front door courtesy light switch assembly (for LH) signal OFF or ON OFF: Front door LH closed
ON: Front door LH open- Body Electrical > Main Body > Data List
Tester Display FR Door Courtesy SW FL Door Courtesy SW OK
On the Techstream screen, ON or OFF is displayed accordingly.
Result
Proceed to OK NG
Result:
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to REMOVAL [09/2014 - ]
Result:
NG
GO TO LIGHTING SYSTEM (Proceed to Front Door Courtesy Switch Circuit). Refer to Door Courtesy Switch Circuit [09/2014 - ]