LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2018 >> RX 450hL >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Lane Control System - Diagnostics (Introduction)) >> Lane Control System >> Data List / Active Test [08/2019 - ] >> Data List / Active Test [08/2019 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test [08/2019 - ]

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Lexus RX 450hL, 2022 Lexus RX 450h, 2021 Lexus RX 450hL, 2021 Lexus RX 450h, and 2020 Lexus RX 450hL. However, it is still accessible from the selected car via links, so may be relevant.
  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Chassis / Lane Control / Data List.
    5. According to the display on the Techstream, read the Data List.

      Chassis > Lane Control > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Total Distance Traveled - - - Cannot be used
      Total Distance Traveled - Unit - - - Cannot be used
      LDA Control Lane control system control status Prohibit or Permit Prohibit: Control prohibited
      Permit: Control permitted      		 -
      Turn Switch (Right) Right turn signal switch status OFF or ON OFF: Right turn signal switch off
      ON: Right turn signal switch on      		 -
      Turn Switch (Left) Left turn signal switch status OFF or ON OFF: Left turn signal switch off
      ON: Left turn signal switch on      		 -
      Vehicle Information (2WD/4WD) - - - Cannot be used
      Vehicle Information (Conv/HV) - - - Cannot be used
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus:
      1. for Lane Control: Chassis / Lane Control / Active Test.
      2. for Combination Meter: Body Electrical / Combination Meter / Active Test.
    5. According to the display on the Techstream, perform the Active Test.

      Chassis > Lane Control > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Meter Buzzer Sounds the meter buzzer Start or Stop Perform this Active Test with the vehicle stopped and the power switch on (IG).

      Body Electrical > Combination Meter > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Meter Display 1 Multi-information display OFF or All -
scientia non olet · About LEMON Manuals