DTC U0100: Lost Communication with ECM / PCM "A"; DTC U0125: Lost Communication with Yaw Rate Sensor Module; DTC U0126: Lost Communication with Steering Angle Sensor Module; DTC U0129: Lost Communication with Brake System Control Module [10/2015 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

2. Perform the following procedure.

   HINT: 

   If the following procedure is not performed, the previously output DTC cannot be detected.

   1. Drive the vehicle at a speed of 5 km/h (4 mph) or more for 5 seconds or more.
3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   Result

   Result	Proceed to
   DTC U0100, U0125, U0126 and U0129 are not output	A
   DTC U0100, U0125, U0126 or U0129 is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] 

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ]