Installation [10/2016 - 09/2020]: Procedure
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2024 Lexus IS 500, 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 500, and 2023 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
- Install the rear height control sensor sub-assembly with the 2 bolts and nut.
Bolt
Torque: 13.5 N*m (138 kgf*cm, 10 ft.*lbf)
Nut
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
- Engage the clamp.
- Connect the connector.
- Install the rear height control sensor sub-assembly with the 2 bolts and nut.
- INSTALL REAR WHEEL LH
Refer to PROCEDURE - Step 8
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [10/2016 - 10/2017] , or refer to INITIALIZATION [10/2017 - 09/2020]
- PERFORM INITIALIZATION
Refer to INITIALIZATION [10/2016 - 09/2020]
- ADJUST HEADLIGHT AIMING
Refer to ADJUSTMENT [10/2016 - 09/2020]